Detached shop feeders
Nearly every Finley property has a shop or a barn. We size and bury the feeder, set the subpanel and disconnect, and add the lighting and receptacles that make the building actually usable.
Finley is unincorporated Benton County southeast of Kennewick, out along Highway 397 toward the river. Rural lots, shops, outbuildings, and older homes with wiring that shows their age. Benton PUD serves the area. Gale Electric covers Finley with free estimates, upfront written pricing, and appointments seven days a week from 8AM to 5PM. Call (509) 205-8146.
Finley is rural in a way Kennewick is not, even though it starts a few minutes past the edge of town. Lots are larger, homes are more spread out, and almost every property has something beyond the house that needs power. A shop, a detached garage, a barn, a pump, a well, or all of them at once. Highway 397 runs the length of it, River View High School anchors the middle, and Two Rivers Park sits down on the water. The electrical work here follows the land use rather than a subdivision plan.
That means feeders, not just fixtures. A shop two hundred feet from the house needs a properly sized buried run, a subpanel, a disconnect, and grounding electrodes at the building, not an extension cord and optimism. Well pumps need dedicated circuits and correct protection. Older Finley homes often carry small services that were adequate when the house was built and are not adequate now. Benton PUD serves Finley, and rural service changes out here take more coordination than an in-town swap, which is worth knowing before you plan a project around a date.

Nearly every Finley property has a shop or a barn. We size and bury the feeder, set the subpanel and disconnect, and add the lighting and receptacles that make the building actually usable.
Rural Finley homes depend on well pumps. A dedicated circuit, correct overcurrent protection, and a serviceable disconnect keep a pump failure from turning into a week without water.
Older Finley houses were built with small services. Adding a shop, a hot tub, central air, or an EV charger usually starts with upgrading the service and the panel first.

Level 2 EV charger installation in Kennewick, Richland and Pasco. Load calculations, 40A to 60A circuits, permit
See details
Out of breaker space for a heat pump, shop, or EV charger? Gale Electric upgrades residential panels across the
See details
Old wiring, no grounds, cloth insulation? Gale Electric rewires homes in Kennewick, Richland, and Pasco with min
See details
Recessed lighting installed in Kennewick, Richland and Pasco homes. IC-rated LED cans, correct spacing, dimming
See details
Ceiling fan installation and replacement in Kennewick, Richland and Pasco. Fan-rated boxes, downrods, balancing,
See details
Electrical troubleshooting in Kennewick, Richland, and Pasco. Tripping breakers, dead outlets, flickering lights
See detailsFree estimates across the Tri-Cities. Call Kyle and the crew, or send the details and we will come look.